2.6 Reference Motors

Instead of searching for motors by parameters (P, I, U, N), replacement motors according to a defined assignment can also be displayed.

Motor references (a set of compiled motors) can be created in the database. These motors can be compiled by the Electrical I&C engineer without considering individual parameters.

Reference Motor Form

Compiling References

In the motor function, open the motor form in search mode via the „Search/Reference“ button
Open the „Reference Motor“ form via the „=…„ button

Motor Assignment/Reference Search

Reference searches can be performed in two ways:

1. Search by Extended Equipment Number

Place the cursor in the „extended equipment number“ field
Open the search function with Ctrl+F
Enter the extended equipment number and click „next“
The assigned motors are displayed in the right field

In the bottom field „*“, a new Inventory Number can be assigned. Duplicate assignments are possible.

2. Search by Inventory Number

Use the Mode function to switch between sorting by extended equipment number and Inventory Number
After mode change, search for the motor with Ctrl+F
The extended equipment number is displayed in the left field
All associated reference motors are shown in the list field below

Deleting a Motor Reference

Select the Inventory Number
Right-click → Delete record

Entries in the reference system have no effect on the motor data. Deleting the reference Inventory Number does not result in deletion of the entire motor record.

Sorting

At the bottom of the form, the important motor parameters are displayed. Clicking on the respective parameter changes the sorting order.

← 2.5 Motor Search | 2.7 Practical Example →

Inhaltsverzeichnis